How to flash a ledger for a pergola? - pergola building plans
Hello, I'm building a pergola attached to the house. The house is of brick up to 10 meters, then your vinyl siding on the roof. The book (2 x 8 x 12 m) is the house where the brick meets the siding can be connected so that surrounded the Council through the coating into 3 parts and pieces on the ground. My plan is milled in the vinyl siding and use coach screws to ensure reduce the Committee that the tunnels behind the facades.
So my question is - how can I flash to ensure the registration and that I sealed this thing?
1. Should I spray some silicone right to pre-drilled holes in the studs for the screws in late?
2. Should I a room (with washers) between the book and the house?
3. When the lightning of the accounts, the amount of flicker I am not prepared to handle on accounts - What can you all the way to the edge, as in a Z-pattern (which I think are ugly), or I can at 90 ° to get, such as L-model? How can I join - the nails?
And finally,
4. Is it necessary to use the J-channel and how the hell should I use?
Monday, January 4, 2010
Pergola Building Plans How To Flash A Ledger For A Pergola?
Subscribe to:
Post Comments (Atom)
You are flashing a rubber, which is supported by tar for Windows. I accept this and moves between the Council and the j-channel. The idea is that water away from areas that do not channel. So take siding. (Most likely to sit the piece from the top and remove the sides. There are probably a J-channel on the stone. This will move. Set your table up there and watch the outside edge. Flasing your windows Rubber spend half on one side of the line and one on the other side. Then I fold a piece of alum. Trim that fit in your book about their brick and barley come, are laid over the brick. Settles with tacks or nails trim panel. Make your first piece of rubber flashing on the edge of alum. pad placed horizontally, or long form. continue to rise over lapping at least the next 2 and probably want 8 "extra length at each end to pass under the coating. Continue until the line you went to leave. Reinsert the screws and the plate wall drawbacks. Take the J-channel, the mapit. At the corners, where the reduction test, a corner and overlaps that can turn contain more water. Replace the cover and make sure it moves freely. The water sinks into the lining of the J-channel and be swept away. Small cracks between the main and J is waterproof, with flickering behind him. Then, when it may not be in the bottom of the clay. Dropping climax. Access to the website of the VSI and order a manual installation. I think it is $ 5. It will not contribute to financial accounting, but also contribute to the day from the techniques, folding techniques, and the installation of siding. It may be an easier way, but I think it will keep you dry ... Hope it helps.
ReplyDelete